Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Instrukcja Użytkownika Pobierz pdf (Strona 47)

7.3.4 Screens

To acvate an output for 4k resoluons via HDMI 1.4 (on units with the 4k hardware opon), drag the adjacent

resources to outputs 2 or 4 and then check the «4k» opon box.

Resources assigned to an output can be applied to another in order to use the outout’s layers on another

output. Resources can only be assigned in blocks with a x number of layers. For example, an Ascender48

normally has 6 layers on each output. You could move the resources from output #2 to output #1 and permit

output #1 to display 12 layers.

A rotaon of the output can be congured (0, 90, 180 or 270°), and enabled on the next page.

A status panel at the boom of each output indicates if the output is

acve and how many layers will be available, based on the number of

output resources that have been applied to this output

7.3.4 Screens

The screens page allows you to map a parcular output to a parcular screen desnaon or part of a screen.

Drag and drop the available outputs into the desired screen desnaon. By default, your screens will mapped

Output #1 = Screen #1, Output #2 = Screen #2 etc. You can change this order and put for example the Output

#3 into the Screen #1

A 4U LiveCore™ unit has up to 4 screens available, but outputs can be combined on a single screen, for

example to create a dual output blend. To setup a dual output blend, increase the size of Screen #1 to be 2x1.

Next, drag and drop an output onto the new empty square to assign it as part of screen 1. Later, you can make

adjustments to the overlap if you will be using this screen as a So Edge blend. See secon 7.3.15 Blending

management for further informaon about So Edge Blend setup.

With 4 available outputs, you can create two Dual output blends if desired.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 117 118

Brak uwag

Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Instrukcja Użytkownika Strona 47