Analog-way Studio Scan XTD620 Instrukcja Użytkownika Pobierz pdf (Strona 16)

Chapter 9 : CONTROL SOFTWARE STUDIO SCAN XTD 620

PAGE 16

Chapter 9 :

CONTROL SOFTWARE

9-1. CONNECTION

• CONNECTING THE RS-232:

Connect the serial port of your Controlling Device to the REMOTE CONTROL (RS-232) connector (DB 9 Female) of

the STUDIO SCAN XTD 620 with a straight cable (DB 9 Female / DB 9 Male).

• PIN-OUT:

PIN # FUNCTIONS

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

DB 9 female

(Rear panel of the STUDIO SCAN XTD620)

• SPEED TRANSMISSION: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

9-2. "STUDIO SCAN REMOTE CONTROL" SOFTWARE

Your STUDIO SCAN XTD620 is shipped with a compatible DOS "STUDIO SCAN CONTROL PROGRAM" (3"1/2

disk). This software allows you to make adjustments and controls by a simple keyboard command (Frame freeze, Image

adjustments, Storage, etc...).

• SOFTWARE INSTALLATION (on DOS PC):

c Turn your computer ON and wait for his complete Starting.

d Insert the disk into the floppy drive.

e Under DOS type in : A:INSTALL A: C: ↵.

• STARTING UP:

c Connect the serial Port of the computer to the RS-232 Remote Connector of the STUDIO SCAN.

d Type in "XTD" followed by the number of the connected Serial port (Ex : "XTD 2" ↵).

e TURN ON all your devices.

When powering ON the STUDIO SCAN, the REMOTE CONTROL RS-232 is automatically activated after a few

seconds. Adjustments are automatically controllable by both front panel and REMOTE CONTROL.

The last modified adjustment will be taken into account.

• USING: - Type in the red letter to activate the control (Ex : "F" for "Freeze").

- Use the 4 arrows for the Hpos, Vpos and Hsize, Vsize control.

- Type in TAB to change the screen.

- Type in ESC to go back to DOS.

NOTE: Type Q for the status of internal firmware.

Analog-way Studio Scan XTD620 Instrukcja Użytkownika Strona 16